Re: error:hsf driver not active NEED HELP
"Linuxant support (Jonathan)" <[email protected]>
| Newsgroups | gmane.linux.drivers.modem.hsf |
|---|---|
| Message-ID | <[email protected]> |
Hi, you are probably affected by a known issue with the currently version (7.18.00.05full) x86_64 HSF driver and it can be fixed by using the patch named 'hsf-7.18.00.05-errno.patch' available at: http://www.linuxant.com/drivers/hsf/downloads-patches.php Regards, Jonathan Technical specialist / Linuxant www.linuxant.com [email protected] Brian Springstead wrote: > Of course I am having problems getting my modem to work. I downloaded > hsfmodem-7.18.0.05x86_64full.tar.gz, upacked > it and did a "make install". I got this package because the others > listed didn't seem to fit my system. It seemed to install ok, then it > asked me to run "hsfconfig". It asked for a location and I accepted the > default which looked right (/lib/modules/2.6.11-1.1369_FC4) I got a done > message, but then I got "ERROR: hsf driver not active". I read the FAQ > (no help, this problem isn't even mentioned). I searched the archives > and found a few other people with this same problem but I didn't find a > solution that worked for me. I got the same results with a web search. > I used "hsfconfig --dumpdiag" but the file it produced was nearly 250k, > so I didn't upload it. > > I tried using modprobe to install these modules but I got: > WARNING: Error inserting hsfosspec > (/lib/modules/2.6.11-1.1369_FC4/exta/hsfosspec.ko): Unknown symbol in > module or unknown parameter (see dmesg) > ...couple more similar messages and then... > FATAL: similar stuff as above > > An "lspci" gives me: > 02:01.0 Communication controller Conexant: Unknown device 2f20 > > I used an application called "list_modem" (in Windows) I found somewhere > on the web on the same machine and it gave me the follow information: > type: HSF > vendor id: 14F1 > device id: 2F20 > subvendor id: 14F1 > subdevice id: 2000 > revision: 00 > > Machine information: > emachines T6212 > AMD64 Athlon 3200+ > 512m RAM > 160G HD > Fedora Core 4 > kernel: standard FC4 install 2.6.11-1.1369_FC4 > > I am open to suggestions, since I am not sure what is the cause of the > problem. Thanks in advance. > Brian > > _______________________________________________ > hsflinux mailing list > [email protected] > https://www.linuxant.com/mailman/listinfo/hsflinux