Re: HSF modem picks up line but Does Not Dial

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Linuxant support (Jonathan) ha scritto:
> Hi,
> 
> please try to use the 'AT &F X1' init. string to see if there is a
> difference. You should also make sure that the right country is selected
> with the 'hsfconfig --country' command in a root shell.
> 
> Regards,
> 
> 
> Jonathan
> Technical specialist / Linuxant
> www.linuxant.com
> [email protected]
> 
> 

hi.. im not the one here...
but i have the same problem:

Country: Italy.. (i've setted it writing "ITALY" when asked in hsfconfig
- --country)

the modem is: Communication Controller: Rockwell International HSF 56k
Data/Fax Modem code (127a:2013)
PCI

i've installed the latest version of the driver.. no problem during install

than i tried with both ppp and wvdial, same problem: pick up the line (i
can ear

here my wvdial.conf

[Dialer Default]
Carrier Check = no  # Tried both with or without this
Init1 = ATZ         # i've tried AT &F X1, too
Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
Modem Type = Analog Modem
ISDN = 0
New PPPD = yes
Phone = .... # here my phone numbar
Modem = /dev/modem   # symlink to /dev/ttySHF0
Username = ...
Password = ...
Baud = 115200

here the wvdial log without comment:

ATZ
OK

ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
OK

ATDTXXXXXXXXX     # the X are the numbar

the line go down after a while..... and it retry with the same result


(can you or any other reply to me? i've not a subscription)

> 
> Rudi Siegling wrote:
>> Hi,
>>
>> I've got an HSF (conexant modem):
>>> From ModemData.txt (scanModem)
>> Class 0780: 14f1:2f10   Communication controller: Conexant: Unknown
>> device 2f10 (rev 01)
>>   SubSystem 16ec:2013  U.S. Robotics: Unknown device 2013
>>
>> and loaded the linuxant (HSF) driver.
>>
>> Using KInternet, my modem picks up the line (I hear the dial tone on the
>> internal speaker) when given atdt1234
>> (1234 as example, or whichever number I have to dial). The modem does
>> not proceed to actually dial the number given, but times out giving the
>> message "No Carrier"
>> I have tried it with and without "Detect Dial Tone" selected through
>> YaST (Suse 9.3)
>>
>> I have also tried dialing out using kppp's Mini-Terminal. I can get the
>> modem to pick up the line, but nothing else.
>>
>> Any suggestions would be appreciated.
>>
>> Regards
>>
>> Rudi Siegling
>>
>> The process waits right after:
>> pppd[0]: --> Modem initialized.
>> pppd[0]: --> Sending: ATDT8628895
>> pppd[0]: --> Waiting for carrier.
>> pppd[0]: ATDT8628895 then timeouts with then next line
>> pppd[0]: NO CARRIER
>>
>> Below is the log generated by KInternet.
>> SuSE Meta pppd (smpppd-ifcfg), Version 1.58 on linux.
>> Status is: disconnected
>> trying to connect to smpppd
>> connect to smpppd
>> Status is: disconnected
>> Status is: connecting
>> pppd[0]: Plugin passwordfd.so loaded.
>> pppd[0]: --> WvDial: Internet dialer version 1.54.0
>> pppd[0]: --> Initializing modem.
>> pppd[0]: --> Sending: ATZ
>> pppd[0]: ATZ
>> pppd[0]: OK
>> pppd[0]: --> Sending: AT Q0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
>> pppd[0]: AT Q0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
>> pppd[0]: OK
>> pppd[0]: --> Sending: ATM1
>> pppd[0]: ATM1
>> pppd[0]: OK
>> pppd[0]: --> Sending: ATX3
>> pppd[0]: ATX3
>> pppd[0]: OK
>> pppd[0]: --> Modem initialized.
>> pppd[0]: --> Sending: ATDT8628895
>> pppd[0]: --> Waiting for carrier.
>> pppd[0]: ATDT8628895
>> pppd[0]: NO CARRIER
>> pppd[0]: --> No Carrier!  Trying again.
>> pppd[0]: --> Sending: ATDT8628895
>> pppd[0]: --> Waiting for carrier.
>> pppd[0]: ATDT8628895
>> Status is: disconnecting
>> pppd[0]: Connect script failed
>> Status is: disconnected
>> pppd[0] died: Connect script failed (exit code 8)
>>
>> _______________________________________________
>> hsflinux mailing list
>> [email protected]
>> https://www.linuxant.com/mailman/listinfo/hsflinux
> 

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQFFQUwPi33/AIKoeisRAv+bAJ0XaRHpVt/6q7CsXXtN/9DxfHAkyQCgl9dd
1BRIBAYw3uG7QTWIYJilNO4=
=yDFy
-----END PGP SIGNATURE-----