Re: trying to get hsf working [eid-20070423-c8b]

Hi,

it is quite possible that more information about the disconnection will 
be left in the /proc/driver/hsf/0/lastcallstatus file just after the 
disconnection and before you attempt to connect again.

You could also try with each of the following init. strings:

---
AT &F W1 +ER=1; +DR=1; +MS=V92,0
AT &F W1 +ER=1; +DR=1; +MS=V92,1
AT &F W1 +ER=1; +DR=1; +MS=V90,0
AT &F W1 +ER=1; +DR=1; +MS=V90,1
AT &F W1 +ER=1; +DR=1; +MS=V34,0
AT &F W1 +ER=1; +DR=1; +MS=V34,1
AT &F W1 +ER=1; +DR=1; +MS=V32B,0
AT &F W1 +ER=1; +DR=1; +MS=V32B,1
AT &F W1 +ER=1; +DR=1; +MS=V32,0
AT &F W1 +ER=1; +DR=1; +MS=V32,1
---

Note that some of these strings might not work at all and it can be 
normal. They also expect that you have a valid license installed.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Patrick wrote:
> Ok I did what you said and it worked like a charm. The only problem I 
> have now is it disconnects about a minute or two after i connect. No 
> error messages it just hangs up. Its Fedora 6 64bit.
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> hsflinux mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/hsflinux