monitoring a single channel

[email protected]
Newsgroups gmane.linux.drivers.prism54.user
Message-ID <[email protected]> 
I am trying to monitor a single channedl and get information about data rates. 
When using the "iwconfig eth1 mode monitor" there doesn't seem to be a way to specify the channel. Also, the transmit rate, signal noise and channel information  is not accessible. 

Is there a way to use the driver as with the Orinoco driver which defines this command :

iwpriv eth1 monitor <mode> <channel> 

Thanks

Philippe
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.