Re: Everything seems to be working ... except no wireless!
Brian Bothwell <[email protected]>
| Newsgroups | gmane.linux.drivers.prism54.user |
|---|---|
| Message-ID | <[email protected]> |
As stated in multiple previous posts, it depends on the revision. The A1 model of that NIC works with prism54. The rest are atheros. On Fri, 5 Mar 2004 23:39:59 -0500 "Dave Feller" <[email protected]> wrote: > Not sure that is a PRISM card - think it is Atheros... > > David Feller > Director Prism Marketing > Conexant > 972-562-7379 > > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Collin > Starkweather > Sent: Tuesday, March 02, 2004 6:19 PM > To: [email protected] > Subject: [Prism54-users] Everything seems to be working ... except no > wireless! > > I have been trying to get wireless (802.11g) working via a D-Link > AirPlus DWL-G650 a.k.a. AirPlus Extreme G (CardBus) on a Dell Inspiron > 4150 and am just about out of ideas. > > The card is specifically mentioned in the kernel config in > > Device Drivers ---> > Networking Support ---> > Wireless LAN (non-hamradio) ---> > Intersil Prism GT/Duette/Indigo PCI/PCMCIA > > so I figure someone has got it working. > > Here is what I know (lots of good details / proof below my sig): > > 0) pcmcia-cs is installed > 1) hotplug and pcmcia are running > 2) The prism54 and firmware_class modules > are installed (and listed with lsmod) > 3) The firmware is in place > 4) lspci seems to think there is a card (or something) there > > When I insert/remove my D-Link AirPlus, however, I don't even get the > two beeps from cardmgr. And yes, in case you're wondering, sound is > working just fine. > > Any ideas? > > Thanks, > > -Collin > > -- > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Collin Starkweather, Ph.D. [email protected] > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > I restart pcmcia just to make sure: > > freak root # /etc/init.d/pcmcia restart > * Stopping pcmcia... [ ok ] > * 'modprobe yenta_socket' failed > * Trying alternative PCIC driver: yenta_socket > * Starting pcmcia... > cardmgr[6815]: watching 2 sockets [ ok ] > freak root # > > I restart hotplug just to make sure: > > freak root # /etc/init.d/hotplug restart > * Stopping USB and PCI hotplugging... [ ok ] > * Starting USB and PCI hotplugging... [ ok ] > freak root # > > I installed the prism54 module and have pcmcia working through the > yenta_socket module (presumably the above modprobe message arose because > the yenta_socket module was already installed): > > freak root # lsmod > Module Size Used by > prism54 44184 0 > firmware_class 6528 1 prism54 > ... blah blah blah ... > yenta_socket 13952 1 > freak root # > > I have the firmware in place: > > freak root # ls -l /usr/lib/hotplug/firmware/ > total 96 > -rw-r--r-- 1 root root 93996 Mar 2 12:59 isl3890 > freak root # > > lspci seems to think the card is there (though I don't know why it call > it an "Unknown device"): > > freak root # lspci > ... blah blah blah ... > 02:01.0 CardBus bridge: Texas Instruments PCI1420 > 02:01.1 CardBus bridge: Texas Instruments PCI1420 > 07:00.0 Ethernet controller: Atheros Communications, Inc.: Unknown > device 0013 (rev 01) > freak root # > > Here are some messages I found in /var/log/messages that I don't quite > know what to make of but which may seem relevant: > > Mar 2 15:26:53 freak cardmgr[6566]: watching 2 sockets > Mar 2 15:26:53 freak cs: IO port probe 0x0c00-0x0cff: clean. > Mar 2 15:26:53 freak cs: IO port probe 0x0800-0x08ff: excluding > 0x800-0x817 0x828-0x837 0x840-0x84f 0x860-0x877 0x880-0x88f 0x898-0x89f > 0x8a8-0x8cf 0x8e0-0x8ff > Mar 2 15:26:53 freak cs: IO port probe 0x0100-0x04ff: excluding > 0x378-0x37f 0x3c0-0x3df 0x4d0-0x4d7 > Mar 2 15:26:53 freak cs: IO port probe 0x0a00-0x0aff: clean. > Mar 2 15:26:53 freak cardmgr[6566]: starting, version is 3.2.5 > > > _______________________________________________ > Prism54-users mailing list > [email protected] > http://prism54.org/mailman/listinfo/prism54-users > _______________________________________________ > Prism54-users mailing list > [email protected] > http://prism54.org/mailman/listinfo/prism54-users >
signature.asc
(application/pgp-signature, 189 B)
-----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.4 (GNU/Linux) iD8DBQFAUU29XFoaje2SLvERAtArAJ4pU3hZRfsGf73V1k3vB13xrorAtACfeE36 P25tS84h8/iN/eJBk94oMa0= =nEJV -----END PGP SIGNATURE-----