SMC2802W V2 (prism54 nitro)

Hi folks,

Somebody wrote once, that this card will probably not be supported by 
the prism54 driver. There exists a sourceforge project which uses the 
Windoze Driver for this card: http://ndiswrapper.sourceforge.net/
You could probably tell that on your homepage. After one day trying to 
get work the prism54 driver I found this project.


Perhaps it is of use for you to have the ouptput of my lspci -vv for 
this card:

00:0c.0 Network controller: Harris Semiconductor D-Links DWL-g650 A1 
(rev 01)
        Subsystem: Accton Technology Corporation: Unknown device ee03
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 56 (2500ns min, 7000ns max), cache line size 08
        Interrupt: pin A routed to IRQ 18
        Region 0: Memory at ea000000 (32-bit, non-prefetchable) [size=8K]
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA 
PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

I'm a little bit confused because it is written that card has the same 
chip like the D-Link DWL-g 650?

Anyway, thank you for your work.
Aurel


-- 
So lange man sich verändern kann, braucht man keine Angst vor dem Leben zu
haben!

(Gutsch)