Re: WG511 Mandrake 10:help!
Bob Farmer <[email protected]>
| Newsgroups | gmane.linux.drivers.prism54.user |
|---|---|
| Message-ID | <[email protected]> |
Firmware should be called isl3890, not isl3890.arm. Also, check your kernel messages upon inserting the card (dmesg or tail /var/log/messages or whatever your kernel log file is) Bob Regis Vincent wrote: >>>>Sounds like the source for your kernel isn't installed. Does the that >>>>link (/lib/modules/2.6.3-4mdk/build) point to a valid directory? >>>> > > I Installed the kernel source (oops...) > Make clean modules > make install > depmode -a > > OK! Thanks a lot! > > Then, Ifconfig eth1 up gives this result: > > "SIOCSIFFLAGS: no such file or directory" > > > Mandrake 10 on a laptop (eth0 is realtek 8139, eth1 is netgear wg511) > > I copied isl3890.arm to /usr/lib/hotplug/firmware. > I put the file firmware.agent in /etc/hotplug. > I executed the "chmod +x /etc/hotplug/firmware.agent > > > What else should I do? I d'rather not wait for the 2.6.5 kernel on mdk! > > PS: at startup, eth1 activation fails. > > > _______________________________________________ > Prism54-users mailing list > [email protected] > http://prism54.org/mailman/listinfo/prism54-users