Re: "54G only" and "Nitro Burst" support

On Wed, May 12, 2004 at 11:34:33PM +0200, Claas Hilbrecht wrote:
> >The only thing I'm missing are the equivalents for the old commands:
> >
> >setoid eth1 17000019 long 3            # Sets Profile to 802.11g only
> >setoid eth1 1b000008 long 5000      # Set Nitro BurstBuffer to 5000
> >
> >Is there a way to set this via some iwpriv commands?
> 
> Is there really no iwpriv command that will do that for the "new" prism54 
> driver?

It is available. I had added the routine a while back. Ajfa then added the
private ioctl recently in his massive patch.

iwpriv eth0 s_profile 3
iwpriv eth0 s_frameburst 5000

	Luis

> 
> -- 
> Claas Hilbrecht
> http://www.jucs-kramkiste.de
> 
> _______________________________________________
> Prism54-users mailing list
> [email protected]
> http://prism54.org/mailman/listinfo/prism54-users

-- 
GnuPG Key fingerprint = 113F B290 C6D2 0251 4D84  A34A 6ADD 4937 E20A 525E

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQFAop8Gat1JN+IKUl4RAuCcAJ9ztfzNYjvlbdn5odJwvmGw8XDVagCfTGvJ
LmbIEkcIutlFVb/fC5QtbeE=
=salL
-----END PGP SIGNATURE-----