Re: netgear wg511 on Gentoo

I'm having the same problem. I don't think there's any solution yet - 
I've been using ndiswrapper instead, which isn't what I'd like, but it
does work. 
Someone noted earlier on this list that there seem to be two different
WG511 types; 
one "Made in China", one "Made in Taiwan", and it's the Chinese ones
that are having 
problems. You should be able to tell which type you have by checking the
label near 
the serial number.

On Sun, 3 Oct 2004 13:49:14 -0500, "Rick Hennigan" <[email protected]>
said:
> Hello everyone.  I have just aquired a Netgear WG511 because I have
> heard it had excellent support under linux.  So far I have not been
> able to get it to work.  Upon inserting the card I get this output
> from dmesg:
> 
> macaroni root # dmesg -c
> PCI: Enabling device 0000:01:00.0 (0000 -> 0002)
> eth1: islpci_open()
> eth1: resetting device...
> eth1: uploading firmware...
> eth1: firmware uploaded done, now triggering reset...
> eth1: device soft reset timed out
> eth1: timeout waiting for mgmt response 1000, triggering device
> eth1: timeout waiting for mgmt response
> eth1: timeout waiting for mgmt response 1000, triggering device
> eth1: timeout waiting for mgmt response
> eth1: timeout waiting for mgmt response 1000, triggering device
> eth1: timeout waiting for mgmt response
> eth1: timeout waiting for mgmt response 1000, triggering device
> eth1: timeout waiting for mgmt response
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgmt tx queue is still full
> eth1: mgt_commit has failed. Restart the device
> 
> lspci -nv gives me:
> 
> 0000:01:00.0 Class 0280: 1260:3890 (rev 01)
>        Subsystem: 1385:4800
>        Flags: bus master, medium devsel, latency 80, IRQ 11
>        Memory at 10800000 (32-bit, non-prefetchable)
>        Capabilities: [dc] Power Management version 1
> 
> After googling around a bit I found that other people were having this
> problem but I couldn't find a solution anywhere.  I am using Gentoo
> Linux kernel 2.6.8 with the prism54 driver that came with gentoo.
> Does anyone know if this problem has a solution yet, and can somebody
> point me in the right direction?  Thanks alot!
> -- 
> Free image hosting at http://www.rickserver.com
> _______________________________________________
> Prism54-users mailing list
> [email protected]
> http://prism54.org/mailman/listinfo/prism54-users
-- 
http://www.fastmail.fm