Re: FCC IDs for cards supported by prism54

On Wed, Nov 03, 2004 at 11:56:21AM -0500, Luis R. Rodriguez wrote:
> supported. If your card is working like a charm, please reply to this
> thread with the card model name as listed from our supported_cards page
> and the FCC ID.
> 
> Then users wanting a supported card can just look for cards that have
> this FCC ID. I'm told it should be on the outside of the box of every
> wireless card.

Full card name: SMC2802W - EZ Connect g 2.4GHz 54 Mbps Wireless PCI Card
Card Model: SMC2802W

lspci -vv -n
0000:00:0a.0 0280: 1260:3890 (rev 01)
        Subsystem: 10b8:2802
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 80 (2500ns min, 7000ns max), Cache Line Size: 0x10 (64
bytes)
        Interrupt: pin A routed to IRQ 177
        Region 0: Memory at cfff8000 (32-bit, non-prefetchable) [size=8K]
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Then I also have a SMC2835 card, unfortunately not at hand. IIRC it
matches completely the appropriate line on the web page (esp. PCI IDs)

BNoth work like a charm. No FCC id anywhere on the package, only a sticker
"Supplier Part Description: SMC2802W EU". IMHO FCC ID's are legally
pointless in Europe, so they are just omitted.

Bye,

Joerg

_______________________________________________
Prism54-users mailing list
[email protected]
http://prism54.org/mailman/listinfo/prism54-users

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQFBiy0OjY4+4PdzvOARAnMdAJ9JR0K4rhdtVw5LThUqHUnimAEI4gCffimb
jbbrwNvDqvniXTF9h+TiyfY=
=9HdR
-----END PGP SIGNATURE-----