RE: ifconfig issue

I am having the same problem whenever I enable either wds or hostapd
support. I am using kernel 2.4.26 and the latest prism54 cvs. Can someone
help?

 

Thanks,

 

Sergio

 

  _____  

From: [email protected]
[mailto:[email protected]] On Behalf Of
[email protected]
Sent: Monday, February 28, 2005 8:01 AM
To: [email protected]
Subject: [Prism54-users] ifconfig issue

 

Hi All, 

 

  i am herewith sending the details of the results that i get when i give
insmod "prism54.o" , "ifconfig eth0"  and  "ifconfig eth0 up".....insmod
works properly and i have also checked using lsmod to verify if the module
has been  inserted prorperly but the problem occurs when i give ifconfig
eth0 up...the kernel version used is 2.4.24....Any help is appreciated....

 

regards

sudha

 

 

# insmod prism54.o

Using /lib/modules/net/prism54.o

Loaded prism54 driver, version 1.2

# ifconfig eth0

eth0   Link encap:Ethernet  HWaddr 00:30:B4:00:00:00

          BROADCAST MULTICAST  MTU:1500  Metric:1

          RX packets:0 errors:0 dropped:0 overruns:0 frame:0

          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0

          collisions:0 txqueuelen:1000

          Interrupt:28 Base address:0xe000

 

#ifconfig eth0 up

eth0: prism54 driver detected card model: PRISM Duette/GT

eth0: islpci_open()

eth0: resetting device...

eth0: uploading firmware..

Unable to handle kernel paging request at virtual address
4bfff000t0800000,8M me                      

alloc_bootmem_low            

pgd = c0e54000ver model core

[4bfff000] *pgd=00000000, *pmd = 00000000ng delay loop... 532.48 BogoMIPSes.


Internal error: Oops: 8f5ailable for scripting, as

CPU: 0s the 

pc : [<c2871aac>]    lr : [<90000013>]    Not taintedode, 413K data, 52K
init)         

# 

# The kernel HO

r3 : 360000ea  r2 : ff00c020  r1 : 00000006  r0 : 00000000

Flags: nzCv  IRQs on  FIQs on  Mode SVC_32  Segment user

Control: 39FF  Table: 00E54000  DAC: 00000015

Process ifconfig (pid: 32, stack limit = 0xc0dbc368)

Stack: (0xc0dbde78 to 0xc0dbe000)

de60:                                                       4bffe030
4bfff000

de80: 4bffe078 00000001 00008914 c0dbde98 00000000 c1fffea0 0080405b
c1e80960

dea0: c1e80960 00000001 00000000 00000001 00000000 00000000 00008914
c2872274

dec0: 00000000 c1e80960 0000dc05 c287251c c1e80800 c1e8082c c1e80960
00000000

dee0: c0dbdf48 c287209c c1e80800 c1e8082c 00000000 c00b76e0 c1e80800
00001043

df00: 00001002 c00b8d04 00000000 00000000 c1e80800 bffffd24 c00ec06c
00000014

df20: 00000000 00000000 1043d792 00000000 4012711c bfffff3a 65746830
0000a580

df40: bfffff3f 00000000 1043d792 00000000 4012711c bfffff3a 00008914
bffffd24

df60: c0e675c0 00000004 ffffffe7 c0dbc000 4012711c 00000000 c00b1554
c0050de8

df80: 400d5180 c000b3bc bffffd64 bffffd24 00000041 00000036 c00175c4
4012711c

dfa0: 00000000 c0017400 bffffd64 c001737c 00000004 00008914 bffffd24
00001043

dfc0: bffffd64 bffffd24 00000041 00015e58 00000003 bffffe6c 4012711c
00000000

dfe0: 00015ff4 bffffd24 000094e8 400d5184 60000010 00000004 60040400
81400000

Backtrace: frame pointer underflow

Function entered at [<c1fffff4>] from [<00002000>]

Backtrace aborted due to bad frame pointer <00002000>

Code: da000004 e4963004 e2444004 e3540000 (e4853004)



Confidentiality Notice 

The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
[email protected] immediately
and destroy all copies of this message and any attachments.

_______________________________________________
Prism54-users mailing list
[email protected]
http://prism54.org/mailman/listinfo/prism54-users