Re: RTL8139C gets stuck with Abnormal Interrupt / Oversized Frame errors
"Vladimir I." <[email protected]> Sun, 17 Nov 2002 12:41:07 +0200
| Newsgroups | gmane.linux.drivers.realtek.devel |
|---|---|
| Message-ID | <[email protected]> |
Donald Becker wrote about "Re: [realtek] RTL8139C gets stuck with Abnormal Interrupt / Oversized Frame errors": > > get very high. The CPU is really loaded during these moments as > > it's busy polling PCMCIA card (it doesn't support bus master). > > Hmmm, that traffic level shouldn't cause this problem! You should check > out what is going on to load the CPU -- I suspect that the wireless card > device driver is disabling interrupt for a long time. The wireless driver (hostap) loads the system about 40% when doing transfers of large packets (moving packets to and from the card takes a lot of time). The CPU utilization gets closer to 100% with small packets. > This was addressed with the following change: > > ---------------------------- > revision 1.35 > date: 2002/10/05 17:24:00; author: becker; state: Exp; lines: +66 -40 > rtl8139.c:v1.21 10/5/2002 Great, I will try it. -- Best Regards, Vladimir Systems Engineer (RHCE)