Re: error w/ "insmod rtl8139.o"

[email protected] wrote:
> Hi,
> 
> I am using redhat's linux 8.0, kernel 2.4.18-14 and I am trying to install a D-
> Link DFE-530TX+ ethernet card on it.  I was able to compile the latest 
> versions of "rtl8139.c" and "pci-scan.c", which I got from 
> http://www.scyld.com/network/rtl8139.html.  There were no errors that 
> resulted.  However, when I try to issue the command "insmod rtl8139.o", it 
> gives me the error of:

You need the tulip driver for this NIC.  The one in the standard kernel should work
just fine.

Ben

> 
> rtl8139.o: init_module: No such device
> Hint: insmod errors can be caused by incorrect module paramters, including 
> invalid IO or IRQ parameters.
> You may find more information in syslog or the output from dmesg
> 
> When I issue the command "insmod pci-scan" everything is fine.  It is only 
> when I issue "insmod rtl8139.o" that I get this error.  Any information ot 
> help from anybody would be greatly appreciated.  Thanks.
> 
> -Ling
> 
> 
>  
> _______________________________________________
> realtek mailing list
> [email protected]
> http://www.scyld.com/mailman/listinfo/realtek
> 


-- 
Ben Greear <[email protected]>       <Ben_Greear AT excite.com>
President of Candela Technologies Inc      http://www.candelatech.com
ScryMUD:  http://scry.wanfear.com     http://scry.wanfear.com/~greear