Re: rx stops after 128KiB?

On Fri, Oct 10, 2003 at 00:29:37 +0200, Tino Keitel wrote:
> On Thu, Oct 09, 2003 at 21:25:12 +0200, Tino Keitel wrote:
> > On Thu, Oct 09, 2003 at 14:15:23 -0400, Donald Becker wrote:
> 
> [...]
> 
> > > Try using the Makefile, which also builds cb_shim.  And set the
> > > PCMCIA configuration as described in 
> > >     http://www.scyld.com/network/updates.html
> > 
> > Thanks, I will look at it.
> 
> Done that. Now I get this in syslog:
> 
> cardmgr[242]: executing: 'modprobe cb_enabler'
> cardmgr[242]: executing: 'modprobe pci-scan'
> kernel: pci-scan.c:v1.11 8/31/2002  Donald Becker <[email protected]>
> http://www.scyld.com/linux/drivers.html
> cardmgr[242]: executing: 'modprobe cb_shim'
> kernel: cb_shim.c:v1.03 7/12/2002  Donald Becker <[email protected]>
> kernel:  http://www.scyld.com/linux/drivers.html
> cardmgr[242]: executing: 'modprobe rtl8139'
> kernel: rtl8139.c:v1.23 3/10/2003 Donald Becker, [email protected].
> kernel:  http://www.scyld.com/network/rtl8139.html
> kernel: PCI device 'RealTek RTL8139C Fast Ethernet' was not assigned an
> IRQ.
> kernel: It will not be activated.
> kernel: cs: cb_config(bus 1)
> kernel:   fn 0 bar 1: io 0x800-0x8ff
> kernel:   fn 0 bar 2: mem 0x60001000-0x600011ff
> kernel:   irq 10
> kernel: cs: cb_enable(bus 1)
> kernel:   bridge io map 0 (flags 0x21): 0x800-0x8ff
> kernel:   bridge mem map 0 (flags 0x1): 0x60001000-0x60001fff
> kernel: Found a RealTek RTL8139C Fast Ethernet at 1/0 address
> 0x801->0x800 IRQ 10.
> kernel: RealTek RTL8139C Fast Ethernet at 1/0 command 0x7.
> cardmgr[242]: executing: './network start eth1'
> kernel: eth1: RealTek RTL8139C Fast Ethernet at 0x800, IRQ 10,
> 00:10:60:5a:02:fd.
> 
> The card will not hang anymore, but receiving only works with 33 KiB/s.
> :-(
> 
> Sending works with about 3 MiB/s.

Has anybody a solution to this problem? I think receiving should also
work with at least 2 MiB/s.

Regards,
Tino