RE: problem: rtl8139 V1.17 and Linux kernel 2.2.19

Oh, that was it!!  My co-worker had switched cables to try to solve a perceived comm problem, and we get the first message when we disconnect, and the second when we re-connect!!  We just confirmed it by connecting and disconnecting the cable again... Great...

Thanks for your quick help!!

> -----Original Message-----
> From: Donald Becker [mailto:[email protected]]
> Sent: Wednesday, July 24, 2002 14:36
> To: Dan Miller
> Cc: [email protected]
> Subject: Re: [realtek-bug] problem: rtl8139 V1.17 and Linux kernel
> 2.2.19
> 
> 
> On Wed, 24 Jul 2002, Dan Miller wrote:
> 
> > We're trying to use a Realtek Ethernet chip (built into the
> > motherboard) on a Linux 2.2.19 system.   
> > 
> > We originally using rtl8139.c version 1.07, but after a few hours
> > under heavy loads (WebStone with 500 connections) it would start to
> > report errors of various sorts.  Today, we tried upgrading 
> to version
> > 1.17, from the scyld web site.  We also obtained pci-scan.c and the
> > required headers from this same page.  When we load this 
> driver pair,
> > it loads successfully, but when we try to ping through the 
> driver, in
> > reports:  
> > 
> > eth0: Abnormal interrupt, status 00000020. 
> > eth0: Abnormal interrupt, status 00002020. 
> 
> Hmmm, this could be either a link change indication (overloaded on the
> RxUnderrun indication), or a RxUnderrun.  Which chip do you have, and
> what is the detection message?  If it's a rtl8139c, the second status
> indicates that the cable has changed length -- perhaps due to the link
> returning.
> 
> -- 
> Donald Becker				[email protected]
> Scyld Computing Corporation		http://www.scyld.com
> 410 Severn Ave. Suite 210		Second Generation 
> Beowulf Clusters
> Annapolis MD 21403			410-990-9993
>