Re: gspca v2 source

On Wed, Jul 2, 2008 at 1:44 PM, Jean-Francois Moine <[email protected]> wrote:

> On Wed, 2008-07-02 at 12:15 -0300, Cláudio Sampaio wrote:
>
> > Did that, but when I plug the camera, that's what happens now:
> >
> > [ 4158.622975] usb 1-2: new full speed USB device using uhci_hcd and
> > address 4
> > [ 4158.706194] usb 1-2: configuration #1 chosen from 1 choice
> > [ 4158.798146] gspca_main: disagrees about version of symbol
> > video_devdata
>         [snip]
>
> May be you did not remove the previous driver from
> the /lib/modules/2.6.../misc/.
>

Ooops... Sorry! But now I did it:rm  /lib/modules/2.6.24-19-generic/misc/*
Then changed to the new gspca directory and did it again:

make install

Then connected the camera. Now I can get is:

[ 8678.977928] usb 1-2: new full speed USB device using uhci_hcd and address
6
[ 8679.044514] usb 1-2: configuration #1 chosen from 1 choice

No more messages and no /dev/video0...

Best regards,
Cláudio

-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08

_______________________________________________
Spca50x-devs mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/spca50x-devs