Re: 046d:08d9 - works with gspca-modules but not 2.6.27-rc3

Jean-Francois Moine wrote, on 30/08/08 15:42:
> First, you must have a running kernel. Say 2.6.27-rc4 (but it may any
> kernel from 2.6.18).
> 
> Assuming you have the kernel sources and you have compiled and installed
> it, you should have:
> - in '/usr/src/linux-2.6.27-rc4/', a file '.config' (which should be the
>   same as '/boot/config').
> - in '/lib/modules/`uname -r`/', a link 'build' which points to
>   '/usr/src/linux-2.6.27-rc4'.
> 
> You have cloned my mercurial tree in '/usr/src/gspca'. Do:
> 
> 	cd /usr/src/gspca
> 	cp /usr/src/linux-2.6.27-rc4/.config v4l/
> 	make menuconfig
> 		(or 'make gconfig'...)
> 
> In menuconfig, add the GSPCA driver if it is not set.
> Then do:
> 
> 	make
> 	sudo make install
> 
> This last command will overwrite all the V4L modules
> of /lib/modules/`uname -r`/kernel/drivers/media/).
> This is normal.
> 
> If your webcam was connected, unplug it and, as root, do:
> 
> 	rmmod gspca_zc3xx
> 	rmmod gspca_main
> 
> Then plug the webcam. There should be no error looking at:
> 
> 	dmesg | tail
> 
> Best regards.
> 

I recompiled the driver on the machine actually running the webcam were 
the kernel source was also compiled, and obtained:

[  951.696017] Linux video capture interface: v2.00
[  951.704010] gspca: main v2.2.0 registered
[  991.684013] gspca: probing 046d:08d9
[  993.556003] zc3xx: probe 2wr ov vga 0x0000
[  993.628004] zc3xx: probe sensor -> 11
[  993.628004] zc3xx: Find Sensor HV7131R(c)
[  993.628004] gspca: probe ok
[  993.628004] usbcore: registered new interface driver zc3xx
[  993.628004] zc3xx: registered


-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/