RE: SMC1255TX/LP Problem - TX errors and Carrier errors X2

On Thu, 22 Aug 2002, Denny Fox wrote:

> ifconfig (another example, not immediately after log data above)
> eth0      Link encap:Ethernet  HWaddr 00:04:E2:42:D4:72
>           inet addr:192.168.20.254  Bcast:192.168.20.255
> Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:42 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:14 dropped:0 overruns:0 carrier:24
>           collisions:0 txqueuelen:100
>           Interrupt:11 Base address:0xec00

I am not an expert in tulip drivers but according to my recent experience
with it, this does not seem to be a driver problem. It is either:

1) cabling problem (try replacing the patch cable, check another wall
plug);
2) switch problem (e.g. one port in the swich sends half of the packets
to its /dev/null, had this experience with even an expensive cisco
switch), try another port in the switch or test with another switch;
3) hardware problem with the card (least likely), try another SMC1255TX.


Hope this helps.

Juhan

_______________________________________________
tulip-bug mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip-bug