Re: asix supported, or not? 2.4 problems
Michael Chaney <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Organization | Michael Chaney Consulting Corporation |
| Message-ID | <[email protected]> |
On Tue, Jul 30, 2002 at 07:21:42AM -0400, Donald Becker wrote: > On Tue, 30 Jul 2002, Brett Dikeman wrote: > > At 3:27 PM -0400 7/29/02, Donald Becker wrote: > > > > > > cards(the V3 I believe), I get tons and tons of errors under even > > >> slight(100kB/sec) load, eventually the interface just completely > > >> stops responding to the world(anywhere from 10 minutes to an hour or > > >> two)... > .. > > Hmm...its just a "dumb" 10/100 netgear switch... > > That rules out the common forced-full-duplex at the switch. Not necessarily. I have 5 or 6 of those "dumb" netgear switches, and the older models have a set of DIP switches on the back to set each individual port to full duplex or auto. Brett should make sure that his either doesn't have the switches or that they're all set to AUTO. Michael -- Michael Darrin Chaney [email protected] http://www.michaelchaney.com/ _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip