Device or resource busy error
"vinod asokan" <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
Hi, Our company makes Network cards. The current development card is a Fibre mode card. It uses 21143-TD MAC chip and intel LXT971A PHY chip. The designated card has Fx mode enabled by means of hardware setting. I am using Turbo Linux 7.0 in a Toshiba dynabook PC. The pcmcia-cs-3.1.27 service loads the tulip_cb driver. The card runs fine. Ping as well ftp works fine. The file transfer (peer to peer) also works with considerable speed. But everytime I remove the card or , when I use "service pcmcia restart", The kernel message says the " device or resource busy". "lsmod tulip_cb " also does not work. I have to ultimately reboot the system , to free the pcmacia resources. Is there any other way by which I can stop the pcmcia service or unload the driver..? Can anyone tell me the possible reasons for the "resource busy " error message ?? Thanks and regards *********************************************** Vinod Asokan _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip