Re: Unresolved symbols w. 2.4.7
Tobias Brandvik <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Sat, Aug 17, 2002 at 04:46:58AM -0400, Donald Becker wrote: > On Fri, 16 Aug 2002 [email protected] wrote: > > > I'm trying to get my Conexant NIC to work on a Compaq Presario 17xl365 > > laptop. Other users of the same laptop have reported success in getting > > the card to work with the tulip driver. I'm using Red Hat 7.2 with > > 2.4.7. Both pci-scan.c and tulip.c compiles, but when doing "insmod" I > > get a lot of messages about "unresolved symbol". > > Try downloading and compiling the driver with > > mkdir /tmp/netdrivers/ > cd /tmp/netdrivers/ > ncftp ftp://ftp.scyld.com/pub/network/netdrivers.tgz > tar xfvz netdrivers.tgz > make > make install > > I'm temporarily recommending this approach instead of the binary or > source RPM. Red Hat has several different kernels that are distributed > as being "7.2", and each requires different module versions. I tried this and it worked just fine -- no messages concerning unresolved symbols. Thanks for your help. Tobias Brandvik [email protected] _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip