Re: PCMPC200 v2 gives Unresolved Symbols on 2.4.7-10
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Sat, 24 Aug 2002, Andrea Lamorgese wrote: > I cannot get my Linksys PCMPC200 v2 CardBus card to work > (on an HP Omnibook XE3-L with Redhat 7.2 -- 2.4.7-10): > after reading one of the messages (by J.A. Pfeil, > Unresolved symbols w. 2.4.7), I tried with netdrivers.tgz > and then make && make install. > Compilation was smooth and insmod pci_scan.o also was, but as > soon as I try --> insmod tulip.o --> I get > > tulip.o: init_module: No such device The driver didn't find a recognized card. > But the above is wrong, right? Then, I tried > make tulip_cb.o --> compilation is okay (no messages). Using drivers compiled to '*_cb.c' is unlikely to work with a standard Red Hat 7.2 system. That distribution uses only in-kernel CardBus drivers. > I did not forget to modify /etc/pcmcia/config > with the manfid as on Linksys website: > > http://www.linksys.com/support/support.asp?spid=26 Errrmm, what line did you put in the config file? -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Second Generation Beowulf Clusters Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip