Re: PCMPC200 v2 gives Unresolved Symbols on 2.4.7-10
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 28 Aug 2002, Jason A. Pfeil wrote: > On Sun, 25 Aug 2002, Donald Becker wrote: > [...snip...] > > > > > > tulip.o: init_module: No such device > > The driver didn't find a recognized card. > Here is the information provided by cat /proc/pci for the netcard: > Ethernet controller: PCI device 1737:ab09 (rev 17). OK, this ID was only added recently: ________________ tulip.c:v0.95b 8/2/2002 Added PCI table entries 1737 ab09 Linksys PCM200 v3 CardBus, ADMtek Centaur-C 1113 1216 SMC1255TX, ADMtek Comet ---------------------------- [[ typing noise in the background ]] I just put out a new version of netdrivers.tgz that includes 0.95b: mkdir /tmp/netdrivers/ cd /tmp/netdrivers/ ncftp ftp://ftp.scyld.com/pub/network/netdrivers.tgz tar xfvz netdrivers.tgz make make install -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Second Generation Beowulf Clusters Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip