Re: PCMPC200 v2 gives Unresolved Symbols on 2.4.7-10
"Jason A. Pfeil" <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
Thank you so much, Donald! The new version compiled and installed just
like a charm!
--Jason
On Wed, 28 Aug 2002, Donald Becker wrote:
> On Wed, 28 Aug 2002, Jason A. Pfeil wrote:
> > On Sun, 25 Aug 2002, Donald Becker wrote:
> > [...snip...]
> > > >
> > > > tulip.o: init_module: No such device
> > > The driver didn't find a recognized card.
> > Here is the information provided by cat /proc/pci for the netcard:
> > Ethernet controller: PCI device 1737:ab09 (rev 17).
>
> OK, this ID was only added recently:
> ________________
> tulip.c:v0.95b 8/2/2002
>
> Added PCI table entries
> 1737 ab09 Linksys PCM200 v3 CardBus, ADMtek Centaur-C
> 1113 1216 SMC1255TX, ADMtek Comet
> ----------------------------
>
> [[ typing noise in the background ]]
>
> I just put out a new version of netdrivers.tgz that includes 0.95b:
>
> mkdir /tmp/netdrivers/
> cd /tmp/netdrivers/
> ncftp ftp://ftp.scyld.com/pub/network/netdrivers.tgz
> tar xfvz netdrivers.tgz
> make
> make install
>
>
>
>
--
Jason A. Pfeil 13700 Richmond Park Dr. N. #1104
Jacksonville, FL 32224
[email protected]
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip