D-Link DFE-660 freezes System
"Michael Tuschik" <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
Hello, i want to use a D-Link DFE-660 cardbus LAN-card in an FSC-Notebook. Sometimes the system freezes, when i insert the card. If not, it freezes when i want to initialize it with an IP-address. I guess it's some sort of resource conflict. But i get no error messages, no log entries, no response :( The system hangs and i have to turn it off. This is my system: Fujitsu Siemens Lifebook X-7530 (P3 500 MHz) D-Link DFE-660 (connected to a 100mbit SMC switch) Debian Linux 3.0 with Linux Kernel 2.4.18 and 2.4.19 Please help, i have no clue what to do. Thanx in advance !! Michael Tuschik Output from the driver, when it loads without freeze: ----------------------------------------------------- tulip_attach(device 08:00.0) tulip.c:v0.91g-ppc 7/16/99 [email protected] (modified by [email protected] for XIRCOM CBE, fixed by Doug Ledford) eth0: Digital DS21143 Tulip rev 65 at 0x200, 00:E0:98:76:E3:E0, IRQ 9. eth0: EEPROM default media type Autosense. eth0: Index #0 - Media MII (#11) described by a 21142 MII PHY (3) block. eth0: MII transceiver #0 config 3000 status 7809 advertising 01e1. Output from "tulip-diag": ------------------------- tulip-diag.c:v2.08 5/15/2001 Donald Becker ([email protected]) http://www.scyld.com/diag/index.html Index #1: Found a Digital DS21143 Tulip adapter at 0x200. Port selection is MII, half-duplex. Transmit stopped, Receive stopped, half-duplex. The Rx process state is 'Stopped'. The Tx process state is 'Stopped'. The transmit threshold is 128. The NWay status register is 000000c6. Internal autonegotiation state is 'Autonegotiation disabled'. Use '-a' or '-aa' to show device registers, '-e' to show EEPROM contents, -ee for parsed contents, or '-m' or '-mm' to show MII management registers. Output from "mii-tool -v": -------------------------- eth0: negotiated 100baseTx-FD, link ok product info: vendor 00:10:18, model 33 rev 2 basic mode: autonegotiation enabled basic status: autonegotiation complete, link ok capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD advertising: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD link partner: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD flow-control _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip