RE: tulip, linksys ethernet card and redhat 7.3

Hi!

> could anyone please tell me how to set up any ethernet card
> (recommendation please) so that i can connect to my dsl?  has anyone
> connected to DSL using redhat 7.3, tulip, and the linksys etherfast
> 10/100 card?  

I connect to DSL using the same config as yours.
What is the mechanism you use for DSL ? Does your ISP
uses PPPoE? My ISP uses PPPoE and I use following methods.

1. If you are using software, ie connecting ethernet port
on PC directly to ADSL modem, then you need to setup
asdl-setup and configure the scripts. Please check
adsl-start,adsl-stop,adsl-setup command manpages.
(This is the rpppoe roaring penguin pppoe product)

2. If you are connecting the ethernet port to a Cable-DSL
router and then hooking the WAN link to the ADSL modem.
You need to run manually the DHCP client
on the linux box with correct ethernet interface
The command I is "dhcpcd <eth0>". In this case pppoe runs on
dsl router.

Regards-

Naga R Narayanaswamy
Lucent Technologies,
8301 Professional Pl
Landover, MD 20785
mailto:[email protected]
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip