DFE-570TX Problem unresolved symbol
Roland Gafner <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
Hi all, I am running Checkpoint SecurePlatform NG FP3 Firewall, which basically is a RH 7.2 distro with a 2.4.9-34 Kernel. Unfortunately the tulip.o module is a bit out of date, it is 0.9.15-pre6 which is not working properly with the DFE-570TX. I downloaded the current netdrivers.tgz which compiled ok, both for pci-scan.o and tulip.o . The module pci-scan.o loads just fine while tulip.o outputs following errors : insmod ./tulip.o ./tulip.o: unresolved symbol netif_rx_Re852beec ./tulip.o: unresolved symbol unregister_netdev_Rc17db26f ./tulip.o: unresolved symbol skb_over_panic_Rea4c35d6 ./tulip.o: unresolved symbol alloc_skb_R0dc786d0 ./tulip.o: unresolved symbol dev_close_R3dc9f8ab ./tulip.o: unresolved symbol __kfree_skb_Ra11ccd27 ./tulip.o: unresolved symbol eth_type_trans_R3a4511d5 ./tulip.o: unresolved symbol init_etherdev_Rf59ba4e3 ./tulip.o: unresolved symbol softnet_data_Rc01f792b Any hints or ideas are appreciated. Tnx rgds Roland -- +++ GMX - Mail, Messaging & more http://www.gmx.net +++ NEU: Mit GMX ins Internet. Günstige DSL- & Modem/ISDN-Tarife! _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip