How do I increase setup_delay?
"Trevor Fraser" <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
Hello all.
I'm still having problems trying to get my pcmcia ethernet card to work on
Red Hat 7.3. I am using the pcmcia package version 3.1.22. I am considering
sending a bug report, but I am not convinced this is a bug by the error
messages I get.
This is the scenario:
I type:
[root@tlaptop root]# service pcmcia restart
and I get this error (and a high beep followed by a low beep):
starting PCMCIA services: modulesYenta IRQ list 08b8, PCI irq 9
Socket status: 30000827
Yenta IRQ list 08b8, PCI irq 9
Socket status: 30000007
cs: socket c0c84800 timed out during reset. Try increasing setup_delay
cardmgr.
How do I increase setup_delay?
Regards,
Trevor Fraser.
Red LinX - Business network and server management and support.
Tel: +27 (0)21 555 3866
Fax: +27 (0)21 552 9299
Cell: +27 (0)83 337 7714
E-mail: [email protected]
Snail-mail: P.O. Box 55 156, Sunset Beach, 7453.
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip