Re: Question about RX-Drop errors and an appearant chipset lockup on the Phobos p430tx NIC.
Ben Greear <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Organization | Candela Technologies |
| Message-ID | <[email protected]> |
Becker's driver dies almost immediately with these console errors: eth[1-4]: Too much work during an interrupt, csr5=0xf06d80c0 .... eth1: Restarted Rx at 2874 / 2874 eth3: Restarted Rx at 296 / 296 ..... If I ramp up traffic slowly, the first 3 ports do OK. When I start the 4th, I see the messages again. However, I saw them on eth2, not eth4, which is the one that I had just started... Ben -- Ben Greear <[email protected]> <Ben_Greear AT excite.com> President of Candela Technologies Inc http://www.candelatech.com ScryMUD: http://scry.wanfear.com http://scry.wanfear.com/~greear _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip