FULL DUPLEX
Homer Wilson Smith <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
Running Linux 2.0.38, tulip.c v.90, and 2 Kingston 21140 Ethercards
connected to 10mps Cisco 1900 switch set to full duplex ports.
/etc/conf.modules says
alias eth0 tulip
alias eth1 tulip
options tulip options=16
Only first card goes into full duplex mode, second and further
cards remain in half dulplex as confirmed by tulip-diag.
Am I out of luck?
------------------------------------------------------------------------
Homer Wilson Smith The Paths of Lovers Art Matrix - Lightlink
(607) 277-0959 KC2ITF Cross Internet Access, Ithaca NY
[email protected] In the Line of Duty http://www.lightlink.com
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip