Re: FULL DUPLEX
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Sun, 3 Nov 2002, Homer Wilson Smith wrote: > DLINK DFE 570TX 4 port with Intel 21143TD chipset. > > I have *NEVER* been able to get a 21143 chip to go into > full duplex with 10BaseT ports. 21140's work fine, and 21143's > work fine with 100BT. > > Running Linux 2.0.38 using latest tulip.c, and pci-scan.c, tulip-diag > SAYS the chip is in full duplex mode, but the full dup light is not on, What driver version? > and the cisco 1900 switch it is connected to shows runt frames and What option are you passing? What is the detection message? -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Scyld Beowulf cluster system Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip