Re: Problems with full-speed routing on a tulip quad interface
Ben Greear <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Organization | Candela Technologies |
| Message-ID | <[email protected]> |
Luke Stratman wrote: > Hello all: > > I'm in the process of configuring several linux boxes to act as high > performance routers in a network testbed environment; the hardware specs > for each of them are as follows: I have been able to __generate__ 90Mbps+ on 4 ports simultaneously, and receive that much on another machine, but even using NAPI and various other tunings, I cannot run 4 ports full-duplex (ie 90Mbps send + 90Mbps receive at the same time). I have not found a chipset that can handle it. If you can get 70Mbps send + receive on 4 ports, you are doing quite well. Ben -- Ben Greear <[email protected]> <Ben_Greear AT excite.com> President of Candela Technologies Inc http://www.candelatech.com ScryMUD: http://scry.wanfear.com http://scry.wanfear.com/~greear _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip