Re: D-Link DFE-680TXD: "The transmitter stopped"
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On 7 Nov 2002, Leif Nixon wrote: > Donald Becker <[email protected]> writes: > > > Please try > > ftp://www.scyld.com/pub/network/test/test/tulip.c > > which has the updated ID. > > No joy, I'm afraid. Still recognized as a 21143; OK, please try these three things: Fix my typo at line 401 -- the ID should be "1541" not "1514". Doh! Use the non- "*_cb" compile of the driver -- see http://www.scyld.com/network/updates.html At line 3500 make the following change to the default: - int i, chip_id = 4; /* DC21143 */ + int i, chip_id = 20; /* ADMtek Centaur-C */ > Nov 7 23:33:33 kaipak cardmgr[586]: socket 1: Linksys EtherFast PCMPC200 v2 > Nov 7 23:33:33 kaipak kernel: cs: cb_alloc(bus 5): vendor 0x1186, device 0x1541 ... > Nov 7 23:33:33 kaipak kernel: eth0: Digital DS21143-xD Tulip rev 17 at 0xc4a78000, EEPROM not present, 00:4C:69:6E:75:79, IRQ 10. -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Scyld Beowulf cluster system Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip