Re: ANA-6944A/TX Question concerning port layout

On 22 Dec 2002, John Cusick wrote:

> I have tried some more troubleshooting and found that switching the pci
> slot results in the following:
> 
> eth0 - int 16
> eth1 - int 16
> eth2 - int 16
> eth3 - int 19

These are IOAPIC mappings, not the 8259-mode mappings reported 

> By the way, the board is a PR440FX with amibios, I mis-reported earlier.

That's a dual Pentium Pro motherboard, one of the best of the era.

> I still have to initiate eth3 first, then eth2, then eth1, then eth0,
> otherwise they will not initiate.

Yes, that is consistent with a IRQ mapping bug.

> I'm using the latest driver as far as I know, v0.95f

What is the detection message with that driver version?

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip