TOO MUCH WORK...

     Running Linux 2.0.38 as a router, Kingston 21140 cards, with tulip
v0.95.

     During nightly 'maintenance' runs involving disk copying and
other jobs, we get this error message.

     Is this serious?

     There is significant traffic going through the router from eth0,
eth1, but hopefully it can handle more in the future, just testing for the
moment.

     Thanks  Homer

Dec 28 15:00:54 fw1 kernel: eth0: Too much work during an interrupt, csr5=0xfc6980c0.
Dec 28 15:00:54 fw1 kernel: eth1: Too much work during an interrupt, csr5=0xfc670040.
Dec 28 15:00:54 fw1 kernel: eth1: Too much work during an interrupt, csr5=0xfc6988c5.
Dec 28 15:00:59 fw1 kernel: eth1: Restarted Rx at 1489930 / 1489930.
Dec 28 15:00:59 fw1 kernel: eth1: Too much work during an interrupt, csr5=0xfc6988c7.
Dec 28 15:00:59 fw1 kernel: eth1: Restarted Rx at 1489930 / 1489930.
Dec 28 15:00:59 fw1 kernel: eth0: Restarted Rx at 1268329 / 1268329.
Dec 28 15:00:59 fw1 kernel: eth0: Too much work during an interrupt, csr5=0xfc6988c7.
Dec 28 15:00:59 fw1 kernel: eth0: Restarted Rx at 1268329 / 1268329.

------------------------------------------------------------------------
Homer Wilson Smith     The Paths of Lovers    Art Matrix - Lightlink
(607) 277-0959 KC2ITF        Cross            Internet Access, Ithaca NY
[email protected]    In the Line of Duty    http://www.lightlink.com

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip