Re: Conexant LANfinity COMBO doenst send anythinf
Donald Becker <[email protected]> Sat, 4 Jan 2003 12:34:06 -0500 (EST)
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Sat, 4 Jan 2003, Adriano Carvalho wrote: > >What is the driver version? > >What is the detection message? > > The driver version is 0.9.15-pre12, but I've downloaded netdrivers.tgz and It doesnt work too. > I've tried with netdrivers-3.3.tgz, and it sends 42 bytes sometimes, but other computes doesnt receive anything. After a time, it stopped. What does 'tulip-diag' report after it stops? What are the error messages from the driver? > dmesg is : > pci-scan.c:v1.11 8/31/2002 Donald Becker <[email protected]> http://www.scyld.com/linux/drivers.html > tulip.c:v0.95f 11/17/2002 Written by Donald Becker <[email protected]> > http://www.scyld.com/network/tulip.html > eth0: Conexant LANfinity rev 8 at 0xd405e000, 00:90:96:02:E4:57, IRQ 11. > eth0: MII transceiver #1 config 1000 status 782d advertising 0020. > eth0: MII transceiver #0 config 1000 status 782d advertising 0020. This looks normal. Two notes The station address has been read correctly, unlike the 0.9.* driver. You seem to have passed a module option that sets the transceiver to advertise only 10baseT. Was that intentional? Does the link partner expect this? -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Scyld Beowulf cluster system Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip