Re: Re: Conexant LANfinity doesnt send anything

On Sat, 4 Jan 2003, Adriano Carvalho wrote:

> Donald Becker wrote :
> >You have an interrupt problem.
> >Interrupts are not causing the interrupt handler to be run.
> >This might be an issue for the kernel mailing list.
> I dont know how to solve it.If anybody can help me, I thanks..
> 
> >The advertised capability is now correct.
> >What does /proc/interrupts report about IRQ11?
> 
> Is it correct ?
> The /proc/interrupts about IRQ 11 is :
> 
> 11:     300432          XT-PIC  Texas Instruments PCI1410 PC card Cardbus 
> Controller, hcf

Try
  shut down the PCMCIA subsystem
     service pcmcia stop
  note the interrupt count for IRQ11  ("300432" in the line above)
  start the network interface
  note the interrupt count for IRQ11

You should get approximately one interrupt for every packet sent or
received.  If you don't, you have a problem with the interrupt routing.

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip