Re: FA511 not passing much data
Donald Becker <[email protected]> Thu, 9 Jan 2003 16:17:06 -0500 (EST)
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On 9 Jan 2003, Jarl Friis wrote: > Donald Becker <[email protected]> writes: > > > On 8 Jan 2003, Jarl Friis wrote: > > > > > Subject: Re: [tulip] FA511 not passing much data > > > > > > Indeed 1385 is Netgear, though 1317 is linksys. > > > > > 02:00.0 Class 0200: 1317:1985 (rev 11) > > > > > Subsystem: 1385:511a > > > > Huh? Where did you get the idea that PCI vendor 1317 is Linksys? > > >From http://pciids.sourceforge.net/iii/?i=1317 > But of course that may be wrong. Do you know the correct PCI ID of > linksys? A board reseller isn't required to have an ID, only the people making the PCI chips. A PCI device must have an ID, and may optionally have a subsystem ID. The board vendor typically programs the subsystem ID with their own values, although a few chips allow the configuration EEPROM to also override the chip's standard PCI ID. The motivation to do this is to appear to have a unique product, for instance when the vendor doesn't want the customer to know that "$80 value" NIC is exactly the same a $6 generic rtl8139 board. Actually, the vendor ID is more general than just PCI devices. Many other devices (e.g. USB) now use a 16+16 bit Vendor/Device ID. Much like the 2+22+24 bit IEEE station address, this kind of standardization is a very good thing. > > This is a ADMtek Comet '985 chip, implemented on a NetGear card. > > Very well, but it seems to be branded under linksys' PCI ID, right? No. The list that Linux uses was apparently user-submitted guesses. And once there is an entry, it is never validated. > > There are several other Ethernet NIC chips in the Centuar/Comet series > > with 0x1317 ID, generally with the format [01]98[135] or 951? > > I have added the entry 1385:511a on > http://pciids.sourceforge.net/iii/?i=13171985 > Do you disagree on this? The 1385:511a is the subsystem ID for the Netgear FA511, which should always use the 1317:1985 ADMtek Comet/Centaur chip. This is similar to the 1385:f311 (subsystem ID) Netgear FA311 v1 board, which always uses the 100B:0020 (primary ID) National Semiconductor DP83815 chip. -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Scyld Beowulf cluster system Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip