Re: Parity error on 2nd Tulip card

On Fri, 7 Feb 2003, Abe Ward Kabakoff wrote:

> After looking through the logs to find this info, it looks like the card
> was always broken, even when it was the only tulip on the system.  Could
> this be a hardware problem?

Yes, it's possible the driver is reporting a real PCI bus problem.
But that doesn't explain the bad counts.

> >What driver version?
> >What is the detection message?
> 
> Linux Tulip driver version 0.9.15-pre12 (Aug 9, 2002)
...
> Is that what you're looking for?

That's a modified driver.  Hopefully someone else can help you with the
problem.

> >>eth1      Link encap:Ethernet  HWaddr 00:04:5A:6E:CF:59
> >>          RX packets:3808455 errors:0 dropped:0 overruns:0 frame:0
> >>          TX packets:0 errors:3934296 dropped:0 overruns:0 carrier:7657130
> >>          collisions:0 txqueuelen:100
> >
> >Yup, this is broken.

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip