Re: the question about hotplug in tulip driver(not buildtin kernel 2.4)

On Wed, 12 Feb 2003, Ming Chuan Huang wrote:

>     I think I may misconfigure hotplug. I use RH 7.3 with default kernel
> version 2.4.18-3 and I use ADMtek 985 cardbus. I modify the file located at
> /lib/module/2.4.18-3/modules.pcimap  and added support to my card.It works
> when I insert my card(It loads the tulip dirver I made,I sure)  and  driver
> does not unload (type lsmod to check) when I remove the card. The timer is
> alive(I add some debug message). I reinsert the card, but it will never work
> until I rmmod driver.

Is there a message from the driver?
Is the usage count '0' in /proc/modules?

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip