Re: Lanfinity keeps breaking under load.

Am Montag, 21. April 2003 20:14 schrieb Donald Becker:
> > The problem is always the same: Under a high (mostly) NFS transmit
> > load, the interface stops working completely.
>
> Where is the error message from the driver when it stops?

There is no real error message. It just stops. Of course transfers time 
out after that but nothing tells me that the interface actually broke 
down.

> > #ifconfig, note that TX bytes is definitely wrong - at this time i
> > had transmitted ~ 120 MB.
>
> I haven't yet tracked down how to get the chip to count Tx packets as
> such (rather than Tx errors) when in full duplex mode.

Ok, I see.

Thanks,

Bernhard
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip