smc1244TX

Hello this is my first mail to the list.


I have the SMC1244TX board:

# lspci 
...
00:0d.0 Ethernet controller: Linksys Network Everywhere Fast Ethernet 10/100 model NC100 (rev 11)
...

#lspci -n 
...
00:0d.0 Class 0200: 1317:0985 (rev 11)
...

OK the diag tool shows this:

# ./tdiag -aaem
tulip-diag.c:v2.17 5/6/2003 Donald Becker ([email protected])
 http://www.scyld.com/diag/index.html
Index #1: Found a ADMtek AL985 Centaur-P adapter at 0xec00.
ADMtek AL985 Centaur-P chip registers at 0xec00:
 0x00: fff98000 ffffffff ffffffff 17a80800 17a80a00 fc06c812 ff970111 fffe5410
 0x40: fffe0000 fffd97f8 00000000 fffe0000 00000000 00000200 00000000 f0000008
 Extended registers:
 0x80: 2006c812 03fe5410 7afe0005 0000ff00 00000000 17a80a20 17a80930 ffe0f000
 0xa0: f0000000 000b000b ffff000b 00000000 40000000 00000000 00000000 00000000
 0xc0: 00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
 0xe0: 00000000 00000000 00000000 00000000 00000000 00000000 00000000 18000027
 Comet duplex is reported in the MII status registers.
 Transmit stopped, Receive stopped.
  The Rx process state is 'Waiting for packets'.
  The Tx process state is 'Stopped'.
  The transmit threshold is 128.
 Interrupt sources are pending!  CSR5 is fc06c812.
   Tx complete indication.
   Link passed indication.
   Timer expired indication.
   Early Rx indication.
  Comet MAC address registers 000b000b ffff000b
  Comet multicast filter 0000000040000000.
EEPROM 64 words, 6 address bits.
  Ethernet MAC Station Address 00:50:bf:9e:12:fb.
  Default connection type 'Autosense'.
  PCI IDs Vendor 1317 Device 0985  Subsystem 1113 ec02
  PCI min_grant 255 max_latency 255.
  CSR18 power-up setting 0xa04c****.
 MII PHY found at address 1, status 0x7849.
 MII PHY #1 transceiver registers:
   1100 7849 001d 2411 05e1 0000 0004 2001
   0000 0000 0000 0000 0000 0000 0000 0000
   1001 0000 1891 205f 0000 000f 7490 0000
   9000 6946 2c58 1326 8911 0444 0230 0000.


and ifconfig this:
eth0    Link encap:Ethernet  HWaddr 0B:00:0B:00:0B:00
	  inet addr:192.168.1.1  Bcast:192.168.1.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:11 Base address:0xa000

The problem i have is that board not transmits well. Pings and short udp packets ( like dns lookups ) works well but TCP not.
if i load iptraf, can see how tcp packets reaches my computer with SA flags but my board not responds to them.

OK. the first thing that is "rare" is the MAC address that ifconfig shows on screen, which is not correct as in diag tool.

I suppose that this board is a little different to similar others.

I hope that something helps me.
thanks and sorry my horrible english.







_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip