Re: Re: smc1244TX

On Thu, 11 Sep 2003, Uxio Faria wrote:

> > What driver version are you using?
> > What is the detection message (shown when booting)?
> 
> I have used some driver versions:
...
> 	eth0: ADMtek Centaur-P rev 17 at 0xd9c4d000, 0B:00:0B:00:0B:00, IRQ 11.
...
> > I'm guessing that you have a lot
> > of error reports in the logs.
> 
> 	In logs i have no errors ( dmesg ) but in stats for eth0 yes. a lot.

My guess is that the kernel debug messages are not being logged.

> > You have an IRQ problem.
> 
> I have no reports for an irq problem.

Does /proc/interrupts should an increasing interrupt count?  The count
should be approximately equal to tx+rx packets, if the network interface
is the only device on the interrupt.

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
914 Bay Ridge Road, Suite 220		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip