Re: DFE 570 TX not working.

Rodrigo Severo <[email protected]> Tue, 16 Dec 2003 10:24:55 -0200
Newsgroups gmane.linux.drivers.tulip.general
Message-ID <[email protected]>
Donald,


After I connected the board to another switch, it worked. Either with=20
stock 2.4.23 kernel's driver or with yours, version "tulip.c:v0.97=20
7/22/2003".

The bad switch isn't broken, i.e. I have several connections on it=20
without any problem. The previous network card on this machine - a=20
Realtek 8139 - worked without problems on this switch also.

Said all this I ask, do you still would like to continue the diagnosis=20
process? I can send all the info you need, and I would like to help, but=20
as the main problem is solved and it doesn't looks like a driver related=20
matter, I'm not sure you want to keep spending time on this matter.


Thanks again for your time, patience and attention,

Rodrigo Severo

Donald Becker wrote:

>On Mon, 15 Dec 2003, Rodrigo Severo wrote:
>
> =20
>
>>I'm just trying to make a DFE 570 TX (4 ports board) work under Linux=20
>>Kernel 2.4.23. The board goes up but I can't ping anything. I don't eve=
n=20
>>get a "Destination unreacheable" error message"!
>>   =20
>>
>
>What driver version are you using, and what is the detection message?
>
> =20
>
>>tulip-diag.c:v2.17 5/6/2003 Donald Becker ([email protected])
>>Index #1: Found a Digital DS21143 Tulip adapter at 0x9800.
>>   =20
>>
>
>Is after you have tried to send packets?
>
> =20
>
>>Digital DS21143 Tulip chip registers at 0x9800:
>> 0x00: f8208400 ffffffff ffffffff 0e5bd000 0e5bd080 f0660000 320c2002 f=
3ff8065
>> 0x40: e0000000 fffdc3ff ffffffff 00000000 000020c7 ffff0001 ffffffff 8=
ff10000
>> Port selection is MII, half-duplex.
>> Transmit started, Receive started.
>>  The Rx process state is 'Waiting for packets'.
>>  The Tx process state is 'Idle'.
>>  The transmit threshold is 128.
>>   =20
>>
>
>This looks normal.  Specifically, there is not packet waiting to be
>transmitted, and interrupts appear to be working.
>
> =20
>
>>I can try Donald's driver but I believe it isn't the recommended
>>solution for a 2.4.x kernel.=20
>>   =20
>>
>
>It works in many cases where the in-kernel version does not, although th=
is
>is not obviously be one of them.
>
> =20
>


--=20
----------------------------------------------------
Rodrigo Severo
F=E1brica de Id=E9ias
Fone: +55(61)321 1357
Fax: +55(61)223 1712
SBS - Quadra 2 - Ed. Empire Center - Sala 1301
Bras=EDlia/DF - Brasil
CEP: 70.070-904
----------------------------------------------------

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip