Advice and Question

Chip Cuntz <[email protected]> Wed, 11 Feb 2004 08:37:26 -0700

Newsgroups	gmane.linux.drivers.tulip.general
Message-ID	<[email protected]>

Donald,

I have been following this list for about a year now.  You seem very knowledgeable and and would like some quick advice.

First the question:  I have an Intel board with onboard either net and was wondering what command will yield all of the information needed to debug (mci-diag).  I think it is having problems with Fedora Core 1.

Now the advice:  If the onboard Ethernet is worthless for on reason or another could you recommend a good, fast, works well with Linux and relatively cheap PCI NIC?

Thank you,

Chip Cuntz
MCI
719.535.1305
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip