RE: What am I missing?

Your configuration on the Red Hat box looks correct.  I was able to use
make it work on a setup over here using your exact ifconfig / vconfig
statements (on a slightly older FC box, 2.6.9-1.667smp.)

I would suspect the switch setup.  You set the adapters up for tagged
packets on VLAN ID 2 and 3, so make sure at least one of the VLANs
office1 or office2 correspond to VLAN ID 2 or 3.

Also make sure the system you are checking connectivity from is
connected to a port configured for the appropriate VLAN and the port is
untagged (unless the system checking for connectivity is also using
something like 8021q.o which would require it to be properly configured
and connected to a properly configured tagged port.)

You are not overlooking the obvious are you?  I assume the VLAN module,
8021q, is loaded on the Linux box.

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Nathan
Sent: Thursday, March 03, 2005 3:15 PM
To: [email protected]
Subject: [VLAN] What am I missing?

I've got a Redhat FC3 box running the 2.6.10-1.741 kernel w/ the stock
e100 driver. I run the following on the box:

ifconfig eth0 0.0.0.0 up
vconfig add eth0 2 
vconfig add eth0 3 

ifconfig eth0.2 10.2.3.122 netmask 255.255.255.0 
ifconfig eth0.3 10.2.5.122 netmask 255.255.255.0

then on the switch (extreme networks black diamond):

config vlan office1 add port 3:35 tagged
config vlan office2 add port 3:35 tagged 

When I try to ping either address niether work. Not sure what I'm
missing here.

_______________________________________________
Vlan mailing list
[email protected]
http://www.lanforge.com/mailman/listinfo/vlan