Unable to see Cisco Native VLAN on a BSD box
"Johan Henes" <[email protected]>
| Newsgroups | gmane.linux.drivers.vlan |
|---|---|
| Message-ID | <[email protected]> |
Hi ! I have set up a dot1q trunk between a Cisco switch and an OpenBSD 3.1 box. Everything works beautifully except of VLAN 1 which is default Native VLAN on the Cisco switch. I am not able to see traffic on this interface on the BSD box until I change Native VLAN on the switch to something else. This of course solves the problem, but I am just curious - is this correct behaviour ?? I know that Native VLAN is untagged, but if I connect a Cisco router instead of the BSD box, Also VLAN 1 (native vlan) is reachable via a VLAN-subinterface on the router.... (And I do of course see the traffic on the physical interface. it is just that i want it to go to the vlan-interface :-) Best regards, Johan _______________________________________________ Vlan mailing list [email protected] http://www.lanforge.com/mailman/listinfo/vlan