Re: VLANs, Cisco Catalyst 5500 (CatOS) and a Realtek 8100 series
Derek Fedel <[email protected]>
| Newsgroups | gmane.linux.drivers.vlan |
|---|---|
| Message-ID | <[email protected]> |
heh, ironically, I just set the native vlans to something that didnt exist, and bam it works. I guess the packets not being tagged were screwing it up. On Sun, 20 Mar 2005 22:45:21 -0800, Derek Fedel <[email protected]> wrote: > I still didnt get it to work, but ok, here we go. My Test lab is as > follows. Why am I using two separate nics you ask? well, because i've > tried it with one nic, and no go. (I have one catalyst 5500, and two > main networks I need to run from them). Again, any help is greatly > appreciated. > > Firewall, 2.6.11.4, one rtl-8100 and one intel (using e100 driver) > > the e100 is aliased to adm > the rtl-8100 is aliased to int > > 3/1 on the switch is the int interface on the firewall > 3/2 is the adm interface. > > Heres the ifconfig output > > int Link encap:Ethernet HWaddr 00:E0:4C:7E:55:5D > inet addr:192.168.2.1 Bcast:192.168.2.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:107751 errors:0 dropped:0 overruns:0 frame:0 > TX packets:3178 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:12742507 (12.1 MiB) TX bytes:400354 (390.9 KiB) > Interrupt:11 Base address:0xe800 > > int.3 Link encap:Ethernet HWaddr 00:E0:4C:7E:55:5D > inet addr:192.168.2.1 Bcast:192.168.2.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:545 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:39830 (38.8 KiB) TX bytes:0 (0.0 b) > > adm Link encap:Ethernet HWaddr 00:A0:C9:36:9D:FF > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:1092 errors:0 dropped:0 overruns:0 frame:0 > TX packets:21 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:76450 (74.6 KiB) TX bytes:966 (966.0 b) > > adm.2 Link encap:Ethernet HWaddr 00:A0:C9:36:9D:FF > inet addr:192.168.3.1 Bcast:192.168.3.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:1058 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:58533 (57.1 KiB) TX bytes:0 (0.0 b) > > Here are some outputs > > istanbul:~# cat /proc/net/vlan/config > VLAN Dev name | VLAN ID > Name-Type: VLAN_NAME_TYPE_RAW_PLUS_VID_NO_PAD > adm.2 | 2 | adm > int.3 | 3 | int > > istanbul:~# cat /proc/net/vlan/adm.2 > adm.2 VID: 2 REORDER_HDR: 1 dev->priv_flags: 1 > total frames received 6519 > total bytes received 919544 > Broadcast/Multicast Rcvd 91 > > total frames transmitted 0 > total bytes transmitted 0 > total headroom inc 0 > total encap on xmit 0 > Device: adm > INGRESS priority mappings: 0:0 1:0 2:0 3:0 4:0 5:0 6:0 7:0 > EGRESSS priority Mappings: > > istanbul:~# cat /proc/net/vlan/int.3 > int.3 VID: 3 REORDER_HDR: 1 dev->priv_flags: 1 > total frames received 7767 > total bytes received 1166438 > Broadcast/Multicast Rcvd 20 > > total frames transmitted 0 > total bytes transmitted 0 > total headroom inc 0 > total encap on xmit 0 > Device: int > INGRESS priority mappings: 0:0 1:0 2:0 3:0 4:0 5:0 6:0 7:0 > EGRESSS priority Mappings: > > Now, for the switch configs. > ut0pia> (enable) sh trunk > * - indicates vtp domain mismatch > Port Mode Encapsulation Status Native vlan > -------- ----------- ------------- ------------ ----------- > 3/1 on dot1q trunking 1 > 3/2 on dot1q trunking 1 > > Port Vlans allowed on trunk > -------- --------------------------------------------------------------------- > 3/1 1,3 > 3/2 2 > > Port Vlans allowed and active in management domain > -------- --------------------------------------------------------------------- > 3/1 1,3 > 3/2 2 > > Port Vlans in spanning tree forwarding state and not pruned > -------- --------------------------------------------------------------------- > 3/1 1,3 > 3/2 2 > > ut0pia> (enable) sh vlan > VLAN Name Status IfIndex Mod/Ports, Vlans > ---- -------------------------------- --------- ------- ------------------------ > 1 default active 5 > 2 VLAN0002 active 826 9/24 > 3 VLAN0003 active 828 3/3-24 > 4/1-24 > 5/1-24 > 6/1-24 > 7/1-24 > 8/1-24 > 9/1-23 > 10/1-24 > 11/1-24 > 12/1-24 > 1002 fddi-default active 6 > 1003 token-ring-default active 9 > 1004 fddinet-default active 7 > 1005 trnet-default active 8 > > VLAN Type SAID MTU Parent RingNo BrdgNo Stp BrdgMode Trans1 Trans2 > ---- ----- ---------- ----- ------ ------ ------ ---- -------- ------ ------ > 1 enet 100001 1500 - - - - - 0 0 > 2 enet 100002 1500 - - - - - 0 0 > 3 enet 100003 1500 - - - - - 0 0 > 1002 fddi 101002 1500 - - - - - 0 0 > 1003 trcrf 101003 1500 - - - - - 0 0 > 1004 fdnet 101004 1500 - - - - - 0 0 > 1005 trbrf 101005 1500 - - - ibm - 0 0 > > VLAN DynCreated RSPAN > ---- ---------- -------- > 1 static disabled > 2 static disabled > 3 static disabled > 1002 static disabled > 1003 static disabled > 1004 static disabled > 1005 static disabled > > VLAN AREHops STEHops Backup CRF 1q VLAN > ---- ------- ------- ---------- ------- > 1003 7 7 off >