RE: linux box as vlan router
"Sunil Parolia" <[email protected]>
| Newsgroups | gmane.linux.drivers.vlan |
|---|---|
| Message-ID | <0894B3ECA7288442AD36FCFA9C0D9D5E2E1CD3@EXCHANGE4> |
Hi all,
I try to emulate vlan setup with this setup
PC-A -→ on vlan2 eth0-0.0.0.0 & eth0.2-192.168.127.141
PC-C -→ on vlan3 eth0-0.0.0.0 & eth0.3-192.168.128.141
PC C acting as vlan router
eth1-0.0.0.0 eth1.2-192.168.127.142
eth2 -0.0.0.0 eth2.3-192.168.128.142
VLAN2 eth2 VLAN3 eth3
PC A ----------------------> PC B ----------------------> PC C
I was able to ping from a to b and from c to b but not a->c & c->a. also when I analyzed pkt in ethereal I found no vlan tag att to pkt.
I’m dumping the output of route and ifconfig.
The routing info & ifconfig at B is
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.128.0 * 255.255.255.0 U 0 0 0 eth2.3
192.168.127.0 * 255.255.255.0 U 0 0 0 eth1.2
192.168.144.0 * 255.255.254.0 U 0 0 0 eth0
default 192.168.144.5 0.0.0.0 UG 0 0 0 eth0
ifconfig-
eth0 Link encap:Ethernet HWaddr 00:07:E9:09:D7:79
inet addr:192.168.144.142 Bcast:192.168.145.255 Mask:255.255.254.0
inet6 addr: fe80::207:e9ff:fe09:d779/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:68255 errors:0 dropped:0 overruns:0 frame:0
TX packets:1599 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:6391334 (6.0 MiB) TX bytes:198958 (194.2 KiB)
Base address:0xdec0 Memory:fe960000-fe980000
eth1 Link encap:Ethernet HWaddr 00:07:E9:09:D5:63
inet6 addr: fe80::207:e9ff:fe09:d563/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:35 errors:0 dropped:0 overruns:0 frame:0
TX packets:69 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3584 (3.5 KiB) TX bytes:6034 (5.8 KiB)
Base address:0xdf00 Memory:fe9a0000-fe9c0000
eth1.2 Link encap:Ethernet HWaddr 00:07:E9:09:D5:63
inet addr:192.168.127.142 Bcast:192.168.127.255 Mask:255.255.255.0
inet6 addr: fe80::207:e9ff:fe09:d563/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:35 errors:0 dropped:0 overruns:0 frame:0
TX packets:45 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2814 (2.7 KiB) TX bytes:3862 (3.7 KiB)
eth2 Link encap:Ethernet HWaddr 00:0D:56:D9:22:24
inet6 addr: fe80::20d:56ff:fed9:2224/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:54 errors:0 dropped:0 overruns:0 frame:0
TX packets:60 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4016 (3.9 KiB) TX bytes:4754 (4.6 KiB)
Base address:0xdf40 Memory:fe9e0000-fea00000
eth2.3 Link encap:Ethernet HWaddr 00:0D:56:D9:22:24
inet addr:192.168.128.142 Bcast:192.168.128.255 Mask:255.255.255.0
inet6 addr: fe80::20d:56ff:fed9:2224/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:28 errors:0 dropped:0 overruns:0 frame:0
TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1680 (1.6 KiB) TX bytes:1776 (1.7 KiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1932 errors:0 dropped:0 overruns:0 frame:0
TX packets:1932 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2546953 (2.4 MiB) TX bytes:2546953 (2.4 MiB)
And at a is
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.128.0 * 255.255.255.0 U 0 0 0 eth0.2
And at b is
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.127.0 * 255.255.255.0 U 0 0 0 eth0.3
I have devoted 2 days but I'm not able to figure out the problem. What is going wrong?? Please direct me where I’m doing mistake.
Thanks ☺
Sunil Parolia
________________________________________
From: [email protected] [mailto:[email protected]] On Behalf Of hareram
Sent: Monday, April 11, 2005 5:20 PM
To: [email protected]
Subject: Re: [VLAN] linux box as vlan router
Hi
yes you can do that with out any effort
if you are newly installing, install selecing all packages
so its installs automatically.
vconfig package for adding vlans
this link may help you
http://www.planetconnect.com/vlan/
hare
----- Original Message -----
From: Sunil Parolia
To: [email protected]
Sent: Monday, April 11, 2005 11:08 AM
Subject: [VLAN] linux box as vlan router
Hi I'm new to vlan. This q may sound absurd, but just wanted to know can we configure standard linux box as vlan router? If yes can anybody direct to relevant site for configuration? I'm using fedora-3 with kernel version of 2.6.9-1.667
Thanks & regards,
Sunil Parolia
________________________________________
_______________________________________________
Vlan mailing list
[email protected]
http://www.lanforge.com/mailman/listinfo/vlan