Proc Priority Mapping

This isn't really an issue just an inconsistency in configuration  
output.  The egress priority and ingress priority display major and  
minor numbers differently.  The ingress maps shows "vlan_qos:  
skb_priority", but the egress map is "skb_priority:vlan_qos".

As a test on my VLAN I assigned the following mappings to both  
ingress and egress (priority:qos): 0:2, 1:3, 2:4, 3:5, 4:6, 5:7, 6:0,  
7:1.  printing the proc file produces:

eth1.2005  VID: 2005     REORDER_HDR: 1  dev->priv_flags: 1
          total frames received:         1027
           total bytes received:        73240
       Broadcast/Multicast Rcvd:            0

       total frames transmitted:          676
        total bytes transmitted:        66630
             total headroom inc:            0
            total encap on xmit:          676
Device: eth1
INGRESS priority mappings: 0:6  1:7  2:0  3:1  4:2  5:3  6:4 7:5
EGRESSS priority Mappings: 0:2 1:3 2:4 3:5 4:6 5:7 6:0 7:1


Egress looks exactly how I expect, but ingress is written in reverse.


John T. Kamenik (Software Eng.)
[email protected]